Toyota Corolla Cross: Diagnosis System
DIAGNOSIS SYSTEM
DESCRIPTION
(a) The transponder key ECU assembly controls the immobiliser system. Immobiliser system data and Diagnostic Trouble Codes (DTCs) can be read through the vehicle Data Link Connector 3 (DLC3).
CHECK DLC3
(a) Check the DLC3.
Click here
.gif)
INSPECT AUXILIARY BATTERY VOLTAGE
(a) Measure the auxiliary battery voltage.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the auxiliary battery.
READ NEXT:
DATA LIST / ACTIVE TEST DATA LIST NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a
DIAGNOSTIC TROUBLE CODE CHART Immobiliser System (w/o Smart Key System)
DTC No. Detection Item
Link B2780
Push Switch / Key Unlock Warning Switch Malfunction
B2
DESCRIPTION This DTC is stored if the transponder key ECU assembly does not detect that the unlock warning switch assembly is on even when the ignition switch is ON.
DTC No. Detection Item
SEE MORE:
DESCRIPTION A flat-type knock control sensor (non-resonant type) has a structure that can detect vibrations between approximately 5 and 23 kHz.
The knock control sensor is fitted onto the engine block to detect engine knocking.
The knock control sensor contains a piezoelectric element which gene
PROCEDURE
1.
CHECK USAGE CONDITIONS
(a) Check that the vehicle and cellular phone meet the following
conditions:
NOTICE:
If changing cellular phone settings, updating software, etc. is
necessary, make sure to obtain the permission of the customer first.
Th
