Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Precaution

PRECAUTION

PRECAUTIONS WHEN USING GTS

(a) When using the GTS with the ignition switch off to troubleshoot:

Connect the GTS to the vehicle, and turn a courtesy light switch on and off at 1.5 seconds intervals until communication between the GTS and vehicle begins.

(b) After all DTCs are cleared, check if the malfunction occurs again 6 seconds after the ignition switch is turned to ON.

PRECAUTION WHEN REPLACING MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (w/ Smart Key System)

(a) If the main body ECU (multiplex network body ECU) is replaced, refer to the Registration.*

  • for HEV Model: Click here
  • for Gasoline Model: Click here
    • *: w/ Start Key System

PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

(a) After turning the ignition switch off, disconnect the cable from the negative (-) auxiliary battery terminal.

NOTICE:

  • After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.

    Click here

  • When disconnecting and reconnecting the auxiliary battery

    HINT:

    When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

    Click here

    READ NEXT:

     Parts Location

    PARTS LOCATION ILLUSTRATION *A w/ Power Back Door System *B w/o Power Back Door System *1 FRONT DOOR LOCK WITH MOTOR ASSEMBLY RH *2 FRONT DOOR COURTESY LIGHT SWIT

     System Diagram

    SYSTEM DIAGRAM

     How To Proceed With Troubleshooting

    CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the power door lock control system. *: Use the GTS. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP

    SEE MORE:

     Multi-axis Acceleration Sensor Module "A" (4WD) Signal Bias Level Out of Range / Zero Adjustment Failure (C052028,...,C117896)

    DESCRIPTION The airbag ECU assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition. The skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag ECU assembly) via CAN communication. These DTCs may be store

     Front Air Mix Damper Control Servo Motor Actuator Stuck Off (B14067F)

    DESCRIPTION The No. 1 air conditioning radiator damper servo sub-assembly sends pulse signals to inform the air conditioning amplifier assembly of the damper position. The air conditioning amplifier assembly activates the motor (normal or reverse) based on these signals to move the air outlet damper

    © 2020-2026 Copyright www.tcorollacross.com PT NL