Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Precaution

PRECAUTION

PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

  • After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.

    Click here

  • When disconnecting and reconnecting the auxiliary battery.

    HINT:

    When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

    Click here

PRECAUTION FOR POWER DISTRIBUTION BOX ASSEMBLY

(a) Do not remove or install the power distribution box assembly with the negative (-) auxiliary battery terminal connected.

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click here

(b) Make sure that the power distribution box assembly is not exposed to water, as it is not waterproof.

(c) Some loads are connected to circuits with dedicated overcurrent protection. Therefore, do not use parts other than those specified for the vehicle.

(d) When replacing the power distribution box assembly, the system may not operate normally if the same part number is not used.

(e) Check that systems are operating normally before proceeding with troubleshooting.

    READ NEXT:

     Parts Location

    PARTS LOCATION ILLUSTRATION *A for LED Type Parking Light without AFS - - *1 NO. 1 ENGINE ROOM RELAY BLOCK - WASHER FUSE

     System Diagram

    SYSTEM DIAGRAM

     System Description

    SYSTEM DESCRIPTION CXPI COMMUNICATION SYSTEM DESCRIPTION (a) The multiplex communication system [CXPI] is used for communication systems between body system components. When communication fails du

    SEE MORE:

     Multi-axis Acceleration Sensor Module "A" Missing Calibration (C051D54,C121054)

    DESCRIPTION The airbag ECU assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition. The skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag ECU assembly) via CAN communication. The DTC is also stored

     System Voltage (BATT) Circuit Short to Ground or Open (P056014)

    DESCRIPTION Auxiliary battery power is supplied to the BATT terminal of the hybrid vehicle control ECU in order to store DTCs and freeze frame data. Even if the ignition switch is turned off, back-up power is supplied. DTC No. Detection Item DTC Detection Condition Trouble Area

    © 2020-2026 Copyright www.tcorollacross.com PT NL