Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Operation Check

OPERATION CHECK

CHECK BASIC OPERATIONS

NOTICE:

Using the multi-information display (combination meter assembly), check that the rear seat reminder function is set to ON.

Click here

HINT:

  • Use the same procedure as for the RH side.
  • If a higher priority notification is displayed on the multi-information display (combination meter assembly), the rear seat reminder will not be displayed.

(a) Operation Check 1:

(1) Turn the ignition switch off.

(2) Open the rear door LH for 2 seconds or more.

HINT:

If a lock operation is performed using the wireless door lock function or entry function after opening and closing the door, the rear seat reminder is not displayed.

(3) Close the rear door LH.

(4) Start the hybrid system within 10 minutes. (for HEV Model)

(5) Start the engine within 10 minutes. (for Gasoline Model)

(6) Turn the ignition switch off, and then check that a rear seat reminder message is displayed on the multi-information display (combination meter assembly).

(7) Perform a door lock operation using the wireless door lock function or entry lock function and check that the hazard warning lights flash 3 times and the wireless buzzer sounds 8 times after the door lock answer-back function operates.

HINT:

If a rear door RH or LH is opened and closed before a door lock operation is performed, the hazard warning lights and wireless buzzer do not operate.

(b) Operation Check 2:

(1) Start the hybrid system. (for HEV Model)

(2) Start the engine. (for Gasoline Model)

(3) Open the rear door LH for 2 seconds or more.

(4) Close the rear door LH.

(5) Turn the ignition switch off, and then check that a rear seat reminder message is displayed on the multi-information display (combination meter assembly).

(6) Perform a door lock operation using the wireless door lock function or entry lock function and check that the hazard warning lights flash 3 times and the wireless buzzer sounds 8 times after the door lock answer-back function operates.

HINT:

If a rear door RH or LH is opened and closed before a door lock operation is performed, the hazard warning lights and wireless buzzer do not operate.

    READ NEXT:

     Customize Parameters

    CUSTOMIZE PARAMETERS CUSTOMIZE REAR SEAT REMINDER SYSTEM NOTICE: When the customer requests a change in a function, first make sure that the function can be customized. Record the current s

     Problem Symptoms Table

    PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of pr

     Seat Heater Switch

    RemovalREMOVAL CAUTION / NOTICE / HINT Procedure Part Name Code 1 SWITCH BASE 55449D - - - 2 REMOVE SEAT HEATER SWITCH 84751F

    SEE MORE:

     Inspection

    INSPECTION PROCEDURE 1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition

     Parts Location

    PARTS LOCATION ILLUSTRATION *1 INVERTER WATER PUMP ASSEMBLY *2 INVERTER WITH CONVERTER ASSEMBLY *3 ECM *4 COMPRESSOR WITH MOTOR ASSEMBLY *5 HYBRID VEHICLE TRANSAXLE ASSEMBLY *6 NO. 1 ENGINE ROOM RELAY BLOCK AND NO. 1 JUNCTION BLOCK ASSE

    © 2020-2025 Copyright www.tcorollacross.com PT NL