Toyota Corolla Cross: Operation Check
OPERATION CHECK
CHECK FUNCTION
(a) Check that the key reminder warning buzzer sounds.
(1) With the driver door closed, insert the key into the ignition key cylinder and then make sure that the ignition switch is off or ACC.
(2) Check that the buzzer sounds intermittently if the driver door is opened.
(b) Check that the key reminder warning buzzer stops.
(1) Check that the buzzer stops sounding if any of the following operations is performed while the buzzer is sounding:
- Close the driver door (driver door courtesy light switch is off).
- Turn the ignition switch to ON.
- Pull out the key from the ignition key cylinder.
READ NEXT:
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order
TERMINALS OF ECU CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND POWER DISTRIBUTION BOX ASSEMBLY
(a) Remove the main body ECU (multiplex network body ECU) from the power distribution box assem
DATA LIST / ACTIVE TEST DATA LIST NOTICE:
In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whethe
SEE MORE:
INSTALLATION CAUTION / NOTICE / HINT
NOTICE:
After replacing the combination meter assembly, make sure to perform update ECU security key.
After performing the update ECU security key procedure, make sure to perform the initialization procedure for when the cable has been disconnected and
DESCRIPTION
The skid control ECU (brake actuator assembly) controls the
brake system warning light (red indicator) in the combination meter assembly via
CAN communication.
PROCEDURE
1.
INSPECT COMBINATION METER ASSEMBLY
(a) Perform the Active Test of the combi
