Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. REMOVE CAM TIMING OIL CONTROL SOLENOID ASSEMBLY

Click here

2. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (EXHAUST CAMSHAFT TIMING GEAR BOLT ASSEMBLY)

(a) Check the stroke of the plunger in the center of the camshaft timing oil control valve assembly (exhaust camshaft timing gear bolt assembly).

Standard Stroke:

2.2 mm (0.0866 in.) or more

If the result is not as specified, replace the camshaft timing oil control valve assembly (exhaust camshaft timing gear bolt assembly).

*a

Plunger

3. INSTALL CAM TIMING OIL CONTROL SOLENOID ASSEMBLY

Click here

    READ NEXT:

     Removal

    REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL) Procedure Part Name Code 1 CAM TIMING OIL CONTROL SOLENOID ASSEMBLY 15370 - - - 2

     Installation

    INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION) Procedure Part Name Code 1 CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (EXHAUST CAMSHAFT TIMING GEA

     Camshaft Position Sensor

    SEE MORE:

     O2 Sensor Circuit Range/Performance Bank 1 Sensor 1 Signal Rate of Change Below Threshold (P2A0026)

    DESCRIPTION Refer to DTC P003012. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Note P2A0026 O2 Sensor Circuit Range/Performance Bank 1 Sensor 1 Signal Rate of Change Below Threshold The calculated value for the air fuel ratio se

     Check Bus 7 Line

    DESCRIPTION Symptom Trouble Area There are ECUs or sensors that display a communication stop on the bus diagnostic screen. Or, there are ECUs or sensors that display communication stop history on the "Detail" screen. CAN main

    © 2020-2025 Copyright www.tcorollacross.com PT NL