Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Inspection

INSPECTION

PROCEDURE

1. INSPECT REAR SEAT INNER BELT ASSEMBLY

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

O84-5(RBR+) - O84-4(RBR-)

Rear RH seat belt unfastened

Below 1 Ω

Rear RH seat belt fastened

10 kΩ or higher

If the result is not as specified, replace the rear seat inner belt assembly.

*a

Component without harness connected

(Rear Seat Inner Belt Assembly)

    READ NEXT:

     Installation

    INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION) Procedure Part Name Code 1 REAR SEAT INNER BELT ASSEMBLY 73580B - -

     Rear Seat Outer Belt Assembly

     Removal

    REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL) Procedure Part Name Code 1 PRECAUTION - - - 2 DISCONNECT CABLE FROM NEGATIV

    SEE MORE:

     Actuator Cut Circuit Stuck Off (P16B09F)

    MONITOR DESCRIPTION The ECM monitors the operation of the throttle actuator. When a malfunction is detected in the throttle actuator cut circuit immediately after the ignition switch is turned off, the ECM illuminates the MIL and stores a DTC. DTC No. Detection Item DTC Detection Condit

     VEHICLE CONTROL HISTORY (RoB)

    VEHICLE CONTROL HISTORY (RoB) DESCRIPTION (SFI SYSTEM) Vehicle Control History (RoB) is a function that captures and stores ECU data when triggered by specific vehicle behavior. If the customer states that the engine stalled or will not start, it may be possible to diagnose the cause of th

    © 2020-2026 Copyright www.tcorollacross.com PT NL