Toyota Corolla Cross: Rear Seat Outer Belt Assembly
READ NEXT:
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 PRECAUTION
-
- -
2 DISCONNECT CABLE FROM NEGATIV
INSPECTION PROCEDURE 1. INSPECT REAR SEAT BELT ASSEMBLY OUTER
(a) Before installing the rear 3 point type seat outer belt assembly, check the ELR function.
NOTICE: Do not disassemble the retr
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 REAR SEAT OUTER BELT ASSEMBLY
73370E
- -
SEE MORE:
TERMINALS OF ECU
NOTICE:
DTCs may be output when connectors are disconnected during inspection.
Therefore, be sure to clear the DTCs using the GTS once the inspection has
been completed.
Do not apply excessive force to the millimeter wave radar sensor assembly
connector.
CHEC
DESCRIPTION Refer to DTC P011511. Click here
HINT: When DTC P011515 is stored, the ECM enters fail-safe mode. During fail-safe mode, the engine coolant temperature is estimated to be 80°C (176°F) by the ECM. Fail-safe mode continues until a pass condition is detected.
DTC No. Detection
Removal
Terminals Of Ecu
