Toyota Corolla Cross: Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR SEAT BELT ASSEMBLY OUTER
| (a) Before installing the rear 3 point type seat outer belt assembly, check the ELR function.
NOTICE: Do not disassemble the retractor. (1) When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.
If the result is not as specified, replace the rear 3 point type seat outer belt assembly. |
|
READ NEXT:
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 REAR SEAT OUTER BELT ASSEMBLY
73370E
- -
DISPOSAL CAUTION / NOTICE / HINT
CAUTION: Before performing pre-disposal deployment of any SRS part, review and closely follow all applicable environmental and hazardous material regulations. Pre-di
SEE MORE:
INSPECTION PROCEDURE 1. INSPECT ENGINE OIL LEVEL SENSOR
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Condition
Specified Condition
1 - Engine oil level sensor body
ON Below 1 Ω
OFF
DESCRIPTION
Each speed sensor detects wheel speed and sends signals to the
skid control ECU (brake actuator assembly). These signals are used by the brake
control.
The speed sensor detects the magnetic fields of the speed sensor
rotor as it rotates and outputs a pulse signal.
The frequency
