Toyota Corolla Cross: Initialization
INITIALIZATION
SERVO MOTOR INITIALIZATION
(a) Press the OFF switch.
(b) According to the GTS display, perform servo motor initialization.
Body Electrical > Air Conditioner > Utility
|
Tester Display |
| Servomotor Initialization |
HINT:
When initialization is started, the AUTO switch indicator will illuminate and then will turn off when initialization has completed.
READ NEXT:
UTILITY REFRIGERANT SHORTAGE CHECK USING GTS (a) Check that the following conditions are met and perform the refrigerant shortage check according to the display on the GTS. Measurement Condition:
PROBLEM SYMPTOMS TABLE
NOTICE:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in ord
TERMINALS OF ECU
CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY
HINT:
Check from the rear of the connector while it is connected to the air conditioning amplifier assembly.
Make sure to wait
SEE MORE:
DESCRIPTION When an open or short circuit is detected in the antenna coil built into the transponder key coil, the transponder key ECU assembly stores this DTC.
DTC No. Detection Item
DTC Detection Condition Trouble Area
Note B2784
Antenna Coil Open / Short
The an
HYDRAULIC TEST
PERFORM HYDRAULIC TEST
CAUTION:
Do not perform a stall test if there are any people or objects near the
vehicle.
The vehicle could begin moving suddenly, resulting in a serious accident.
Do not perform a stall test if any wheel chocks are out of position.
T
