Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: If you think something is wrong

Toyota Corolla Cross (2022-2025) Owner's Manual / When trouble arises / Steps to take in an emergency / If you think something is wrong

If you notice any of the following symptoms, your vehicle probably needs adjustment or repair. Contact your Toyota dealer as soon as possible.

Visible symptoms

  • Fluid leaks under the vehicle.

    (Water dripping from the air conditioning after use is normal.)

  • Flat-looking tires or uneven tire wear
  • Engine coolant temperature gauge needle continually points higher than normal.

Audible symptoms

  • Changes in exhaust sound
  • Excessive tire squeal when cornering
  • Strange noises related to the suspension system
  • Pinging or other noises related to the engine

Operational symptoms

  • Engine missing, stumbling or running roughly
  • Appreciable loss of power
  • Vehicle pulls heavily to one side when braking
  • Vehicle pulls heavily to one side when driving on a level road
  • Loss of brake effectiveness, spongy feeling, pedal almost touches the floor

    READ NEXT:

     Fuel pump shut off system

    To minimize the risk of fuel leakage when the engine stalls or when an airbag inflates upon collision, the fuel pump shut off system stops the supply of fuel to the engine. Restarting the engine Follo

     If a warning light turns on or a warning buzzer sounds

    Calmly perform the following actions if any of the warning lights comes on or flashes. If a light comes on or flashes, but then goes off, this does not necessarily indicate a malfunction in the system

     If a warning message is displayed

    The multi-information display shows warnings for system malfunctions and incorrectly performed operations, and messages that indicate a need for maintenance. When a message is displayed, perform the

    SEE MORE:

     On-vehicle Inspection

    ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: To prevent injury due to contact with an operating V-ribbed belt or cooling fan, keep your hands and clothing away from the V-ribbed belt and cooling fans when working in the engine compartment with the engine running or the ignition switch ON

     Inspection

    INSPECTION PROCEDURE 1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (for 2WD) (a) Preparation for check. (1) Confirm the standard, high and low positions of the link that will be used in the following inspection. The standard position is 53° from the maximum link angle (high) and 113° f

    © 2020-2025 Copyright www.tcorollacross.com PT NL