Toyota Corolla Cross: Fuel Pump (for High Pressure)
READ NEXT:
ON-VEHICLE INSPECTION PROCEDURE
1. FUEL PUMP ASSEMBLY OPERATION (a) Check fuel pressure. (1) Connect the GTS to the DLC3.
(2) Turn the power switch on (IG). (3) Turn the GTS on. (4) Put the engine
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 PRECAUTION
-
- -
2 DISCHARGE FUEL SYSTEM PRESSUR
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 PRECAUTION
-
- -
2 DISCHARGE FUEL SYSTEM PRESSUR
SEE MORE:
DESCRIPTION The ECM and engine stop and start ECU send and receive signals via CAN communication.
If a communication error occurs between the ECM and engine stop and start ECU, the ECM stores this DTC.
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Note
REPLACEMENT
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed and installed, or replaced during
the transfer case oil seal removal/installation are shown below.
Necessary Procedures After
On-vehicle Inspection
Lost Communication with Stop and Start Control Module Missing Message (U110387)
