Toyota Corolla Cross: Fuel Pressure Sensor
READ NEXT:
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 PRECAUTION
-
- -
2 DISCHARGE FUEL SYSTEM PRESSUR
INSPECTION PROCEDURE 1. INSPECT NO. 2 FUEL PRESSURE SENSOR
(a) Check the No. 2 fuel pressure sensor output voltage.
(1) Apply 5 V between terminals 1 (VC) and 3 (E2).
NOTICE:
Be caref
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 NO. 2 FUEL PRESSURE SENSOR
89458H
- -
2
SEE MORE:
INSPECTION PROCEDURE 1. INSPECT CYLINDER HEAD SUB-ASSEMBLY
(a) Using a precision straightedge and feeler gauge, measure the warpage of the contact surfaces where the cylinder head sub-assembly contacts the cylinder block sub-assembly, intake manifold and exhaust manifold.
*a Bottom Si
If the engine will not start
even though correct starting
procedures are being followed, consider
each of the following
points:
The engine will not start
even though the starter
motor operates normally.
One of the following may be the
cause of the problem:
There may not be sufficient
fuel in the
Removal
Inspection
