Toyota Corolla Cross: Fuel Injector (for Port Injection)
READ NEXT:
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 FUEL PIPE CLAMP
23841K -
- -
2 FUEL TUBE SUB-ASSEMBLY
INSPECTION PROCEDURE 1. INSPECT PORT FUEL INJECTOR ASSEMBLY
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
T
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 PORT FUEL INJECTOR ASSEMBLY
23250F
- -
2
SEE MORE:
MONITOR DESCRIPTION A monitor will run when the engine is started at an engine coolant temperature of -10 to 50°C (14 to 122°F). If certain conditions are met, a DTC is stored after the engine idles for 13 seconds (2 trip detection logic).
This DTC is designed to monitor the ignition timing at c
DESCRIPTION If a hybrid vehicle control ECU that is incompatible with the immobiliser function is installed, the hybrid vehicle control ECU will store this DTC.
DTC No. Detection Item
DTC Detection Condition Trouble Area
Note B279C95
Engine Immobiliser System Incorrect
Removal
Cold Start Ignition Timing Performance (P050B00)
