Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Front Door Belt Moulding

READ NEXT:

 Removal

REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL) Procedure Part Name Code 1 FRONT DOOR INSIDE HANDLE BEZEL PLUG 69284F - - 2 DOOR ASSI

 Installation

INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION) Procedure Part Name Code 1 FRONT DOOR BELT MOULDING ASSEMBLY 75720 - - - 2 FRONT

 Front Door Outside Moulding

SEE MORE:

 Terminals Of Ecu

TERMINALS OF ECU CHECK MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY (a) Disconnect the L7 multiplex network master switch assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector disc

 Cold Start Ignition Timing Performance (P050B00)

MONITOR DESCRIPTION A monitor will run when the engine is started at an engine coolant temperature of -10 to 50°C (14 to 122°F). If certain conditions are met, a DTC is stored after the engine idles for 13 seconds (2 trip detection logic). This DTC is designed to monitor the ignition timing at c

© 2020-2026 Copyright www.tcorollacross.com PT NL