Toyota Corolla Cross: Exhaust Manifold (for Awd)
READ NEXT:
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 FRONT FLOOR CENTER BRACE
57533B -
- -
2 FRONT EXHAUST P
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 NO. 2 EXHAUST MANIFOLD HEAT INSULATOR
17168 -
- -
SEE MORE:
DESCRIPTION
The airbag ECU assembly has a built-in yaw rate and acceleration
sensor and detects the vehicle condition.
The skid control ECU (brake actuator assembly) receives signals
from the yaw rate and acceleration sensor (airbag ECU assembly) via CAN communication.
These DTCs may be store
ON-VEHICLE INSPECTION
PROCEDURE
1. CONNECT GTS
(a) Connect the GTS to the DLC3 with the engine switch off.
(b) Start the engine and run it at idle.
(c) Turn the GTS on.
(d) Enter the following menus: Chassis / Brake/EPB / Active Test.
HINT:
Refer to the GTS operator's manual for further
Removal
Multi-axis Acceleration Sensor Module "A" (4WD) Signal Bias Level Out of Range
/ Zero Adjustment Failure (C052028,...,C117896)
