Toyota Corolla Cross: Diagnosis System
DIAGNOSIS SYSTEM
DLC3 (Data Link Connector 3)
(a) Check the DLC3.
Click here .gif)
AUXILIARY BATTERY VOLTAGE
Standard Voltage:
|
Switch Condition
|
Specified Condition
|
|
Ignition switch ON
|
11 to 14 V
|
- If the voltage is below 11 V, replace or recharge the auxiliary battery.
NOTICE:
After turning the ignition switch off, waiting time may be required before
disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore,
make sure to read the disconnecting the cable from the negative (-) auxiliary
battery terminal notices before proceeding with work.
Click here
READ NEXT:
FREEZE FRAME DATA
FREEZE FRAME DATA
Refer to Hybrid Control System.
Click here
FAIL-SAFE CHART
If any of the following DTCs are stored, the hybrid vehicle control ECU enters
fail-safe mode to allow the vehicle to be driven temporarily.
Charging System
DTC No.
DATA LIST / ACTIVE TEST
DATA LIST
(a) According to the display on the GTS, read the Data List.
Click here
ACTIVE TEST
(a) According to the display on the GTS, perform the appropriate Active Tes
SEE MORE:
PRECAUTION
CAUTION:
Failure to carry out service procedures in the correct sequence could cause SRS parts to unexpectedly deploy and possibly lead to serious injuries. Furthermore, if a mistake is made when servicing SRS parts, they may fail to operate when required. Before performing servicin
DESCRIPTION This DTC is stored when the SSW1 contact signal, SSW2 contact signal and SSW3 contact signal, which are detected when the ignition switch is operated, do not match.
DTC No. Detection Item
DTC Detection Condition Trouble Area
Note B227862
Engine/Power Switch
