Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Definition Of Terms

DEFINITION OF TERMS

Term

Definition

Monitor description

Description of what the TCM monitors and how it detects malfunctions (monitoring purpose and details).

Related DTCs

Group of diagnostic trouble codes that are output by the TCM based on the same malfunction detection logic.

Typical enabling condition

Preconditions that allow the TCM to detect malfunctions.

With all preconditions satisfied, the TCM stores a DTC when the monitored value(s) exceeds the malfunction threshold(s).

Sequence of operation

The priority order that is applied to monitoring if multiple sensors and components are used to detect the malfunction.

While one sensor is being monitored, the next sensor or component will not be monitored.

Required sensor/Components

The sensors and components that are used by the TCM to detect malfunctions.

Frequency of operation

The number of times that the TCM checks for malfunctions per driving cycle.

"Once per driving cycle" means that the TCM detects a malfunction only once during a single driving cycle.

"Continuous" means that the TCM detects a malfunction every time the enabling conditions are met.

Duration

The minimum time for which the TCM must detect a continuous deviation in the monitored value(s) in order to store a DTC. Timing begins after the "typical enabling conditions" are met.

Typical malfunction thresholds

Value beyond which the TCM will determine that there is a malfunction and store a DTC.

MIL operation

MIL illumination timing after a malfunction is detected.

"Immediate" means that the TCM illuminates the MIL the instant the TCM determines that there is a malfunction.

"2 driving cycles" means that the TCM illuminates the MIL if the same malfunction is detected again in the next driving cycle.

Component operating range

Normal operation range of sensors and solenoids under normal driving conditions.

Use these ranges as a reference.

The ranges cannot be used to judge if a sensor or solenoid is defective or not.

    READ NEXT:

     Parts Location

    PARTS LOCATION ILLUSTRATION *1 TCM *2 ECM *3 BRAKE ACTUATOR ASSEMBLY - SKID CONTROL ECU *4 NO. 1 EN

     System Diagram

    SYSTEM DIAGRAM

     How To Proceed With Troubleshooting

    CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the continuously variable transaxle system. *: Use the GTS. PROCEDURE 1. VEHICLE BROUGH

    SEE MORE:

     Data List / Active Test

    DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the GTS to read the Data List allows the values

     Transfer System

    Precaution PRECAUTION PRECAUTION (a) Before disassembling the transfer assembly, thoroughly clean it to remove any foreign matter. This will help prevent contamination inside the transfer during disassembly and reassembly. (b) When removing the transfer cover or any other light alloy parts

    © 2020-2025 Copyright www.tcorollacross.com