Toyota Corolla Cross: Customize Parameters
CUSTOMIZE PARAMETERS
CUSTOMIZE SMART KEY SYSTEM (for Start Function)
NOTICE:
- When the customer requests a change in a function, first make sure that the function can be customized.
- Record the current settings before customizing.
HINT:
The following items can be customized.
(a) Customizing with the GTS
Click here .gif)
(b) Customizing with the multi-display
Click here
ENTRY CANCEL FUNCTION (MANUAL OPERATION)
Click here
READ NEXT:
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order
TERMINALS OF ECU
NOTICE:
When performing an inspection, make sure that "ACC Customize" is set to "ON" using the multi-display.
Click here
When "ACC Customize" is set to "ON" (ACC supply po
DATA LIST / ACTIVE TEST DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whethe
SEE MORE:
FREEZE FRAME DATA FREEZE FRAME DATA (a) Whenever a DTC is detected, the multiplex network door ECU stores the current vehicle state as Freeze Frame Data.
CHECK FREEZE FRAME DATA (a) Enter the following menus: Body Electrical / Back Door / Trouble Codes. Body Electrical > Back Door
Tester D
OPERATION CHECK
HINT:
This function shows the telematics network status when the DCM (telematics
transceiver) was operated. Use this when no DTC is present but this telematics
system was unable to connect to the call center. This symptom may occur
if cell phone signal strength is ve
