Toyota Corolla Cross: Turn signal lever
Operating instructions
.png)
- Right turn
- Lane change to the right
(move the lever partway and
release it)
The right hand signals will flash 3
times.
- Lane change to the left
(move the lever partway and
release it)
The left hand signals will flash 3
times.
- Left turn
■Turn signals can be operated
when
The engine switch is in ON.
■If the indicator flashes faster
than usual
Check that a light bulb in the front or
rear turn signal lights has not burned out.
READ NEXT:
The parking brake can be
set or released automatically
or manually.
In automatic mode, the
parking brake can be set or
released automatically
according to shift lever
operation. Also, even in
automat
The brake hold system
keeps the brake applied
when the shift lever is in D,
M or N with the system on
and the brake pedal has
been depressed to stop the
vehicle. The system
releases the brake when the
SEE MORE:
DESCRIPTION
The airbag ECU assembly has a built-in yaw rate and acceleration
sensor and detects the vehicle condition.
These DTCs are stored when the skid control ECU (brake actuator
assembly) receives a malfunction signal from the yaw rate and acceleration sensor
(airbag ECU assembly).
DESCRIPTION The camshaft position sensor (for exhaust camshaft) (EV1 signal) consists of a magnet and MRE (Magneto-Resistive Element).
The exhaust camshaft has a timing rotor for the camshaft position sensor. When the exhaust camshaft rotates, changes occur in the air gaps between the timing rotor
