Toyota Corolla Cross: Brake Pedal (for Hev Model)
READ NEXT:
REMOVAL
CAUTION / NOTICE / HINT
COMPONENTS (REMOVAL)
Procedure
Part Name Code
1
INSTRUMENT PANEL SAFETY PAD ASSEMBLY
ADJUSTMENT
PROCEDURE
1. INSPECT AND ADJUST BRAKE PEDAL HEIGHT
(a) Remove the front door scuff plate LH.
Click here
(b) Remove the cowl side trim sub-assembly LH.
Click here
(c) Turn back th
INSTALLATION
CAUTION / NOTICE / HINT
COMPONENTS (INSTALLATION)
Procedure
Part Name Code
1
BRAKE PEDAL PAD
47
SEE MORE:
INSPECTION PROCEDURE 1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (for 2WD)
(a) Preparation for check. (1) Confirm the standard, high and low positions of the link that will be used in the following inspection.
The standard position is 53° from the maximum link angle (high) and 113° f
INITIALIZATION Inspection After Repair Perform Learning Value Reset and Idle Learning after replacing or servicing parts related to engine operation. Details on procedures required are indicated by an asterisk and a number, and are explained in detail following the table.
Part Replaced Engin
Removal
Inspection
