Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Brake Hold Operated Indicator Light Circuit

DESCRIPTION

The brake hold operated indicator light illuminates when the brake hold system is operating (vehicle stopped due to brake fluid pressure hold) and turns off when the brake hold system operation is finished (brake fluid pressure decreases).

The brake hold system may not operate depending on vehicle conditions even when the system is in standby mode and the brake hold standby indicator light is illuminated.

If there is a system malfunction that causes brake hold control to be prohibited, when the vehicle is under the following conditions and the brake hold switch (electric parking brake switch assembly) is pressed, the brake hold operated indicator light blinks.

  • Vehicle Conditions:
    1. The driver door is closed.
    2. The driver seat belt is fastened.

HINT:

  • When the ignition switch is turned off during brake hold operation, control stops.
  • If brake hold control does not operate even when the vehicle stops, depress the brake pedal again firmly to stop the vehicle.

    If brake hold control still does not operate, confirm the conditions for brake hold control to operate.

PROCEDURE

1.

PRE-CHECK

(a) Check that the brake hold standby indicator light operates normally.

Click here

(b) If the brake hold operated indicator light does not illuminate even though the brake hold standby indicator light is illuminated, check that the following brake hold operation (brake fluid pressure is being maintained ) conditions are met.

  1. System is in operation standby state (brake hold standby indicator light is illuminated).
  2. Shift position is not P or R.
  3. Driver is depressing brake pedal and vehicle is fully stopped.
  4. Driver is not depressing accelerator pedal.
  5. Vehicle is not on steep decline.
  6. The parking brake is not engaged.

HINT:

If a malfunction occurs in one of the following systems, the brake hold operated indicator light will blink. If this occurs, perform troubleshooting on the malfunctioning system.

  • Electronically controlled brake system
  • Electric parking brake system
  • Hybrid control system
NEXT

INSPECT METER / GAUGE SYSTEM

    READ NEXT:

     Steering Angle Sensor Wrong Installation (X0455)

    DESCRIPTION Code Tester Display Measurement Item Trouble Area Output ECU X0455 Steering Angle Sensor Wrong Installat

     Yaw Rate Sensor Wrong Installation (X0456)

    DESCRIPTION The airbag ECU assembly has a built-in yaw rate and acceleration sensor. Code Tester Display Measurement Item Trouble Area Output

     Zero Point Calibration of Yaw Rate Sensor Undone (X204C)

    DESCRIPTION The airbag ECU assembly has a built-in yaw rate and acceleration sensor. Code Tester Display Measurement Item Trouble Area Output

    SEE MORE:

     Passenger Seat Belt Pretensioner "A" Deployment Control Circuit Short to Battery (B007212)

    DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Test Mode / Check Mode B007212 Passenger Seat Belt Pretensioner "A" Deployment Control Circuit Short to Battery One of the following conditions is met: The airbag E

     Fuel pump shut off system

    To minimize the risk of fuel leakage when the engine stalls or when an airbag inflates upon collision, the fuel pump shut off system stops the supply of fuel to the engine. Restarting the engine Follow the procedure below to restart the engine after the system is activated. 1. Turn the engine switch

    © 2020-2025 Copyright www.tcorollacross.com PT NL