Toyota Corolla Cross: Brake Fluid (for Gasoline Model)
READ NEXT:
COMPONENTS
ILLUSTRATION
*1
CENTER COWL TOP VENTILATOR LOUVER
*2
BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY
*3
HOOD
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT BRAKE FLUID LEVEL IN RESERVOIR
(a) Check the fluid level.
HINT:
If the brake fluid level is lower than the MIN line, inspect
f
BLEEDING
CAUTION / NOTICE / HINT
NOTICE:
Move the shift lever to P and apply the parking brake before bleeding
the brakes.
Add brake fluid to keep the level between the MIN and MAX lines
SEE MORE:
DESCRIPTION The motor generator control ECU (MG ECU) (built into the inverter with converter assembly) compares the engine speed value calculated based on the camshaft position signal input from the ECM versus the engine speed value received from the ECM via CAN communication, and when it has freque
PRECAUTION PRECAUTIONS WHEN USING GTS (a) When using the GTS with the ignition switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under
Components
Camshaft Position Sensor "A" Circuit Bank 1 or Single Sensor Algorithm Based Failure (P034006,P034062)
