Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: ABS does not Operate

DESCRIPTION

When the electronically controlled brake system is operating, as the input piston and output piston are not directly connected, the kickback of the brake pedal is minimal during ABS operation and the driver may not notice that ABS operated.

PROCEDURE

1.

BRAKE PROBLEM CHECK

(a) Check if the slip indicator light was illuminated or blinking when ABS did not operate.

HINT:

  • When the VSC system is normal and ABS is operating, the slip indicator light blinks.
  • When the VSC system is malfunctioning, the slip indicator light illuminates.

Result

Proceed to

The slip indicator light was blinking.

A

The slip indicator light was illuminated.

B

A

END

B

2.

CHECK DTC AND FREEZE FRAME DATA

(a) Using the GTS, check DTCs and Freeze Frame Data.

Chassis > Brake Booster > Trouble Codes Chassis > Brake/EPB > Trouble Codes

Result

Proceed to

DTCs are not output.

A

DTCs are output.

B

B

REPAIR CIRCUITS INDICATED BY OUTPUT DTCS

A

3.

PERFORM OPERATION CHECK DRIVING

(a) Check that ABS operates using a drum tester or equivalent.

CAUTION:

When using a drum tester, enter Inspection Mode or VSC off mode and perform inspection with the TRAC and VSC systems disabled to prevent the vehicle from moving suddenly due to TRAC or VSC operation.

Click here

OK:

ABS operates.

OK

END

NG

REPLACE BRAKE ACTUATOR ASSEMBLY

    READ NEXT:

     ABS Operates Before Necessary When Braking

    DESCRIPTION Troubleshooting for when ABS operates too soon due to a noisy signal from the speed sensor, a difference in output, etc. PROCEDURE 1. PERFORM DEALER MODE (SIGNA

     VSC does not Operate or VSC does not Operate Correctly

    DESCRIPTION When TRAC or VSC is operating, the skid control ECU (brake actuator assembly) blinks the slip indicator light to inform the driver that slippage occurred. When a communication malfunct

     VSC OFF Switch Circuit

    DESCRIPTION The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication. Pressing the VSC OFF switch turns off TRAC operation, and pressing

    SEE MORE:

     IG Circuit Short to Ground (B227111)

    DESCRIPTION This DTC is stored when a malfunction in the IG drive circuit or IG hold circuit of the certification ECU (smart key ECU assembly) or a malfunction in the IG output circuit between the output terminal of the certification ECU (smart key ECU assembly) and IG relay is detected. DTC N

     Lost Communication with Hybrid/EV Powertrain Control Module Missing Message (U029387)

    DESCRIPTION The battery ECU assembly transmits and receives signals via CAN communication to and from the hybrid vehicle control ECU. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate Note U029387 Lost Communication with Hybrid

    © 2020-2025 Copyright www.tcorollacross.com