Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Vehicle information display

■ Drive information

Displays drive information such as the following:

Vehicle status information and indicators

  1. Drive information 1
  2. Drive information 2

Displays the following depending on which drive information type and drive information items were selected in .

  • After start
  • Distance: Displays the distance driven since engine start
  • Elapsed time: Displays the elapsed time since engine start
  • Average vehicle speed: Displays the average vehicle speed since engine start
  • After reset
  • Distance: Displays the distance driven since the display was reset*
  • Elapsed time: Displays the elapsed time since the display was reset*
  • Average vehicle speed: Displays the average vehicle speed since the display was reset*

*: To reset, display the desired item and press and hold the OK meter control switch.

■ AWD operation status display (if equipped)

Vehicle status information and indicators

The illustration used is intended as an example, and may differ from the image that is actually displayed on the multi-information display.

  1. Torque distribution display

Displays the drive status of each wheel in 6 steps from 0 to 5.

    READ NEXT:

     Settings display

    ■ Meter display settings that can be changed Language Select to change the language displayed. Units Select to change the units of measure displayed. Meter Type Select to change the meter t

     Suggestion function (if equipped)

    Displays suggestions to the driver in the following situations. To select a response to a displayed suggestion, use the meter control switches. ■ Suggestion to enable the power back door (if equipp

     Fuel consumption information

    Fuel consumption information can be displayed on the audio system screen. System components Audio system screen Displaying fuel consumption screen Select on the main menu. Select "Trip informa

    SEE MORE:

     Replacement

    REPLACEMENT CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the transfer case oil seal removal/installation are shown below. Necessary Procedures After

     System detection range

    ■ Detection range of the sensors Approximately 3.3 ft. (100 cm) Approximately 4.9 ft. (150 cm) Approximately 2.0 ft. (60 cm) The diagram shows the detection range of the sensors. Note that the sensors cannot detect objects that are extremely close to the vehicle. The range of the sensors

    © 2020-2026 Copyright www.tcorollacross.com PT NL