Toyota Corolla Cross: Utility
UTILITY
HINT:
- With "All Readiness", you can check whether or not the DTC judgment
has been completed by using the GTS.
- You should check "All Readiness" after simulating malfunction symptoms
or for validation after finishing repairs.
ALL READINESS
(a) Clear the DTCs even if no DTCs are stored.
Chassis > Rear Camera > Clear DTCs
(b) Turn the ignition switch off and wait for 2 minutes or more.
(c) Turn the ignition switch to ON.
(d) Perform the DTC judgment driving pattern to run the DTC judgment.
Chassis > Rear Camera > Utility
|
Tester Display
|
|
All Readiness
|
(e) Input the DTCs to be confirmed.
(f) Check the DTC judgment result.
|
GTS Display
|
Description
|
| If the judgment result shows Incomplete,
perform the DTC confirmation driving pattern again. |
|
Normal
|
- DTC judgment completed
- System normal
|
|
Abnormal
|
- DTC judgment completed
- System abnormal
|
|
Incomplete
|
- DTC judgment not completed
- Perform the driving pattern
|
CLEAR IMAGE INFORMATION
HINT:
This utility is used to clear the image information stored in the
parking assist ECU.
(a) Perform "Image Information Clear " according to the display
on the GTS.
Chassis > Rear Camera > Utility
|
Tester Display
|
|
Image Information Clear
|
IMAGE RECORDING SETTING
HINT:
This utility is used to enable/disable image recording.
(a) Perform "Image Recording Setting" according to the display
on the GTS.
Chassis > Rear Camera > Utility
|
Tester Display
|
|
Image Record Setting
|
READ NEXT:
PROBLEM SYMPTOMS TABLE
NOTICE:
The following inspection procedures for the parking assist monitor system
are based on the assumption that the audio and visual system is normal.
If the aud
TERMINALS OF ECU
REAR TELEVISION CAMERA ASSEMBLY
(a) Disconnect the rear television camera assembly connector.
(b) Measure the voltage on the wire harness side connector according
to the value(
DIAGNOSIS SYSTEM
PARKING ASSIST MONITOR SYSTEM DIAGNOSTIC MODE
(a) In diagnostic mode for the parking assist monitor system, signals
received by the radio and display receiver assembly can be chec
SEE MORE:
REGISTRATION PROCEDURE 1. ECU EXCHANGE
NOTICE:
When replacing the engine stop and start ECU, make sure to download the number of starter operations (step 1). After replacing the engine stop and start ECU (step 2), write the number of starter operations to the new engine stop and start ECU (ste
PRECAUTION
TIRE PRESSURE WARNING ECU AND RECEIVER EXPRESSIONS
(a) The type of tire pressure warning ECU and receiver used on this model differs
according to the specifications of the vehicle. The expressions listed in the table
below are used in this section.
Vehicle Specification