Toyota Corolla Cross: Taking out the jack
1. Remove the deck mat.
.png)
2. Take out the jack.
2WD models:
.png)
- For tightening
- For loosening
AWD models:
.png)
- Disengage the tightening
strap.
Taking out the spare tire
1. Remove the deck mat.
2. Remove the tool tray.
2WD models:
.png)
AWD models:
.png)
3. Loosen the center fastener
that secures the spare tire.
.png)
WARNING
■When storing the spare tire
Be careful not to catch fingers or
other body parts between the
spare tire and the body of the
vehicle.
READ NEXT:
1. Chock the tires.
2. Vehicles with a steel wheel:
Remove the wheel ornament
using the wrench.
Insert the wrench into the notch A
on the wheel cap.
To protect the wheel ornament,
place a rag betw
1. Remove any dirt or foreign
matter from the wheel contact
surface.
If foreign matter is on the wheel
contact surface, the wheel nuts
may loosen while the vehicle is in motion, causing the tire to c
If the engine will not start
even though correct starting
procedures are being followed, consider
each of the following
points:
The engine will not start
even though the starter
motor operates normall
SEE MORE:
DESCRIPTION
This DTC is output when an open circuit or short occurs in the
communication line between a front center ultrasonic sensor (FLC sensor) and the
front corner ultrasonic sensor (FL sensor), or when a malfunction occurs in a front
center ultrasonic sensor (FLC sensor) on the front.
The distance from your
vehicle to objects, such as a
wall, when parallel parking
or maneuvering into a
garage is measured by the
sensors and communicated
via the audio system screen
and a buzzer. Always check
the surrounding area when
using this system.
System components
■ Types of sensors
Fron
