Toyota Corolla Cross: System Diagram
SYSTEM DIAGRAM
READ NEXT:
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedure listed to troubleshoot the Dynamic Torque Control
AWD System.
*: Use the GTS.
PROCEDURE
1.
VEHICLE BROU
Calibration
CALIBRATION
NOTICE:
Initial AWD functions such as acceleration are sometimes affected unless
backup memory is cleared.
When the yaw rate and acceleration sensor (airbag ECU assembly) is rep
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If
multiple suspected areas are listed, the potential causes of the symptoms are
listed in
SEE MORE:
Lubrication System
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE
1. CHECK ENGINE OIL LEVEL (a) Warm up and stop the engine, then wait for 5 minutes.
(b) Check that the engine oil level is between the low level and full level marks on the engine oil level dipstick.
If the level is low, check for engine oil
Airbag Signal Signal Plausibility Failure (B15C464)
DESCRIPTION
If the DCM (telematics transceiver) detects an error in communication
between the DCM (telematics transceiver) and the airbag ECU assembly as a result
of the DCM (telematics transceiver) self check, this DTC will be stored.
DTC No.
Detection Item
DT
© 2020-2024 Copyright www.tcorollacross.com
