Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Recirculated/Fresh Air Modes do not Switch

Toyota Corolla Cross (2022-2025) Service Manual / Vehicle Interior / Heating / Air Conditioning / Air Conditioning System (for Gasoline Model With Manual Air Conditioning System) / Recirculated/Fresh Air Modes do not Switch

DESCRIPTION

If the air inlet mode cannot be changed between recirculation/fresh or exhaust gas odors can be smelled even though recirculation mode is selected, the following factors may be the cause.

Symptom

Factor
  • Air inlet mode cannot be changed between recirculation/fresh
  • Exhaust gas odors can be smelled when air inlet mode set to recirculation mode
  • No. 1 blower damper servo sub-assembly malfunction
  • Damper link disconnection
  • Air inlet damper mechanically locked
  • Engine coolant temperature (high)
  • Air conditioner unit assembly malfunction

PROCEDURE

1.

CHECK NO. 1 BLOWER DAMPER SERVO SUB-ASSEMBLY

(a) Check that the No. 1 blower damper servo sub-assembly is installed correctly.

OK:

The No. 1 blower damper servo sub-assembly is installed correctly.

NG

INSTALL NO. 1 BLOWER DAMPER SERVO SUB-ASSEMBLY

OK

2.

CHECK FOR DTC

(a) Check for DTCs.

Body Electrical > Air Conditioner > Trouble Codes

Result

Proceed to

B143A87 and B143B7F is not output

A

B143A87 is output

B

B143B7F is output

C
B

GO TO DTC B143A87

C

GO TO DTC B143B7F

A

3.

READ VALUE USING GTS

(a) Read the Data List according to the display on the GTS.

Powertrain > Engine > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Coolant Temperature

Engine coolant temperature

Min.: -40°C (-40°F), Max.: 140°C (284°F)

75 to 100°C (167 to 212°F): After warming up

This is the engine coolant temperature.

HINT:

  • After warming up the engine, the engine coolant temperature will be 75 to 100°C (167 to 212°F).
  • After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature will be approximately equal.
  • If the value is -40°C (-40°F), or higher than 135°C (275°F), the sensor circuit is open or shorted.
  • Check if the engine overheats if the value indicated is higher than 135°C (275°F).
Powertrain > Engine > Data List

Tester Display

Coolant Temperature

OK:

After warming up the engine, the temperature value displayed is within the range specified in the normal condition column.

OK

REPLACE AIR CONDITIONER UNIT ASSEMBLY

NG

GO TO COOLING SYSTEM

    READ NEXT:

     No Cool Air Comes Out

    DESCRIPTION If warm air blows from the registers regardless of the temperature setting of the air conditioning system, the following factors may be the cause. Symptom Factor No cool ai

     Air Vent cannot be Switched

    DESCRIPTION If the air outlet mode does not change even though the air outlet display changes, the following factors may be the cause. Symptom Factor Air outlet mode cannot be changed

     No Warm Air Comes Out

    DESCRIPTION If cool air blows from the registers regardless of the temperature setting of the air conditioning system, the following factors may be the cause. Symptom Factor No wa

    SEE MORE:

     Tongue Plate Stopper

    ComponentsCOMPONENTS ILLUSTRATION *1 TONGUE PLATE STOPPER - - ● Non-reusable part - - ReplacementREPLACEMENT PROCEDURE 1. REMOVE TONGUE PLATE STOPPER (a) Slide the tongue plate above the installation position of the tongue plate stopper, and tempora

     On-vehicle Inspection

    ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT RADIO SETTING CONDENSER (a) With the radio setting condenser installed, check that there is no looseness or other abnormalities. (b) Measure the resistance of the radio setting condenser according to the value(s) in the table below.

    © 2020-2025 Copyright www.tcorollacross.com PT NL