Toyota Corolla Cross: Rear Seat Inner Belt Assembly (for Lh Side)
READ NEXT:
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 REAR CENTER SEAT OUTER BELT ASSEMBLY
73350C -
- -
2 BEN
INSPECTION PROCEDURE 1. INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY
(a) for LH Belt: (1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 REAR SEAT INNER WITH CENTER BELT ASSEMBLY
73480
-
SEE MORE:
ON-VEHICLE INSPECTION
PROCEDURE
1. CONNECT GTS
(a) Connect the GTS to the DLC3 with the engine switch off.
(b) Start the engine and run it at idle.
(c) Turn the GTS on.
(d) Enter the following menus: Chassis / Brake/EPB / Active Test.
HINT:
Refer to the GTS operator's manual for further
BEFORE STARTING DRIVING ADJUSTMENT
CAUTION / NOTICE / HINT
HINT:
Purpose of millimeter wave radar beam axis learning
If the installation position or orientation of the millimeter
wave radar sensor is changed due to it being removed and reinstalled
or replaced with a new one
Removal
On-vehicle Inspection
