Toyota Corolla Cross: On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT COOLER CONDENSER ASSEMBLY
(a) If the cooler condenser assembly fins are dirty, clean them with water and dry them with compressed air.
NOTICE:
Do not damage the cooler condenser assembly fins.
(b) If any cooler condenser assembly fins are bent, straighten them using a screwdriver or pliers.
2. INSPECT FOR REFRIGERANT LEAK
(a) Using a halogen leak detector, check the pipe joints for refrigerant leaks.
(b) If a refrigerant leak is detected in a joint, check the torque of the bolt of the joint.
READ NEXT:
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
-
- -
DISASSEMBLY CAUTION / NOTICE / HINT COMPONENTS (DISASSEMBLY)
Procedure Part Name Code
1 COOLER DRYER
88474
- -
● Non-reusable
REASSEMBLY CAUTION / NOTICE / HINT COMPONENTS (REASSEMBLY)
Procedure Part Name Code
1 COOLER DRYER
-
- -
N*m (kgf*cm, ft.*l
SEE MORE:
DESCRIPTION Refer to DTC P001001. Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Note
P001200 Camshaft Position "A" - Timing Over-Retarded Bank 1
With engine warmed up and while driving in urban area (engine speed 4000 rpm or less
The USB charging port are used
to supply 3.0 A of electricity at 5
V to external devices.
The USB charging port are for
charging only. They are not
designed for data transfer or
other purposes.
Depending on the external
device, it may not charge properly.
Refer to the manual
included with the dev
