Toyota Corolla Cross: Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR CENTER SEAT OUTER BELT ASSEMBLY
| (a) Before installing the rear center seat outer belt assembly, check the ELR function.
NOTICE: Do not disassemble the retractor. (1) When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.
If the result is not as specified, replace the rear center seat outer belt assembly. |
|
READ NEXT:
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 REAR CENTER SEAT OUTER BELT ASSEMBLY
73350C -
- -
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 REAR CENTER SEAT OUTER BELT ASSEMBLY
73350C -
- -
2 BEN
SEE MORE:
DISASSEMBLY CAUTION / NOTICE / HINT COMPONENTS (DISASSEMBLY)
Procedure Part Name Code
1 HEADLIGHT ECU SUB-ASSEMBLY
-
- -
*A w/ AFS
- -
*1 HEADLIGHT UNIT ASSEMBLY
- -
● Non-reusable part
- - CAUT
ON-VEHICLE INSPECTION PROCEDURE
1. FUEL PUMP ASSEMBLY OPERATION (a) Check fuel pressure. (1) Connect the GTS to the DLC3.
(2) Start the engine. (3) Turn the GTS on. (4) Enter the following menus: Powertrain / Engine / Active Test / Control the Target Fuel Pressure Offset / Fuel Pressure (High).
