Toyota Corolla Cross: Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)
| (a) Measure the resistance according to the value(s) in the table below.
Standard Resistance: |
Tester Connection | Condition |
Specified Condition | |
O49-3(+) - O49-2(-) |
Driver side seat belt unfastened |
Below 1 Ω | |
Driver side seat belt fastened |
10 kΩ or higher | If the result is not as specified, replace the front seat inner belt assembly. |
 |
|
*a | Component without harness connected
(Front Seat Inner Belt Assembly) | | |
2. INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)
| (a) Measure the resistance according to the value(s) in the table below (seat belt warning switch).
Standard Resistance: |
Tester Connection | Condition |
Specified Condition | |
j15-3(+) - j15-2(E) |
Front passenger side seat belt unfastened |
Below 1 Ω | | Front passenger side seat belt fastened |
10 kΩ or higher | If the result is not as specified, replace the front seat inner belt assembly. |
 |
|
*a | Component without harness connected
(Front Seat Inner Belt Assembly) | | |
(b) Measure the resistance according to the value(s) in the table below (occupant detection sensor line).
Standard Resistance:
|
Tester Connection | Condition |
Specified Condition |
|
j15-5(+) - A-1 | Always |
Below 1 Ω |
|
j15-4(E) - A-3 | Always |
Below 1 Ω |
If the result is not as specified, replace the front seat inner belt assembly.
READ NEXT:
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 FRONT SEAT INNER BELT ASSEMBLY
73230
- -
PRECAUTION CAUTION: Replace any faulty parts of the seat belt systems (outer belt, inner belt, bolts, nuts, adjustable shoulder anchor, tether anchor hardware and other related parts). When inspecting
SEE MORE:
DESCRIPTION Refer to DTC P010511. Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Note
P01052A Manifold Absolute Pressure / Barometric Pressure Sensor Signal Stuck in Range
Intake manifold pressure measured after engine start drops
DESCRIPTION When an internal malfunction occurs in the ID code box (immobiliser code ECU), the certification ECU (smart key ECU assembly) stores this DTC.
DTC No. Detection Item
DTC Detection Condition Trouble Area
Note B279046
ID-BOX Calibration / Parameter Memory Fail
