Toyota Corolla Cross: Initialization
INITIALIZATION
SERVO MOTOR INITIALIZATION
(a) Press the OFF switch.
(b) According to the GTS display, perform servo motor initialization.
Body Electrical > Air Conditioner > Utility
|
Tester Display |
| Servomotor Initialization |
HINT:
When initialization is started, the AUTO switch indicator will illuminate and then will turn off when initialization has completed.
READ NEXT:
UTILITY REFRIGERANT SHORTAGE CHECK USING GTS (a) Check that the following conditions are met and perform the refrigerant shortage check according to the display on the GTS. Measurement Condition:
PROBLEM SYMPTOMS TABLE
NOTICE:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in ord
TERMINALS OF ECU
CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY
HINT:
Check from the rear of the connector while it is connected to the air conditioning amplifier assembly.
Make sure to wait
SEE MORE:
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT AUTOMATIC LIGHT CONTROL SENSOR (a) Disconnect the h1 automatic light control sensor connector.
(b) Measure the voltage and resistance according to the value(s) in the table below.
Standard Voltage:
Tester Connection Condition
Spec
DESCRIPTION Refer to the description for DTC P0AD911.
Click here
DTC No. Detection Item
DTC Detection Condition
Trouble Area MIL
Warning Indicate Note
P0AD915 Hybrid/EV Battery Positive Contactor Circuit Short to Auxiliary Battery or Open
Open or
