Toyota Corolla Cross: Hybrid Transaxle Fluid
READ NEXT:
COMPONENTS
ILLUSTRATION
*1
DRAIN PLUG
*2
FILLER PLUG
*3
GASKET
-
-
Tightenin
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT HYBRID TRANSAXLE FLUID
(a) Using a 10 mm hexagon socket wrench, remove the filler plug and gasket
from the rear traction motor with transax
ADJUSTMENT
CAUTION / NOTICE / HINT
NOTICE:
For the hybrid transaxle fluid, use Toyota Genuine e-Transaxle Fluid TE.
Using transmission fluid other than the above type may cause abnormal noise or
SEE MORE:
DESCRIPTION The EV mode switch signal will be sent to the hybrid vehicle control ECU when the EV mode switch is operated. If the specified conditions are met, the system enters EV drive mode and the vehicle will be driven using EV drive mode. This signal is then transmitted from the hybrid vehicle c
DESCRIPTION Refer to DTC P003012. Click here
HINT: Although the DTC titles say O2 sensor, these DTCs relate to the air fuel ratio sensor (sensor 1).
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Note
P219519 A/F (O2) Sensor Signal Biased/Stuck Le
Components
Pattern Select Switch EV Mode Circuit
