Toyota Corolla Cross: Front Lower Ball Joint
READ NEXT:
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT FRONT LOWER BALL JOINT ASSEMBLY
(a) Check for looseness.
(1) Lift up the vehicle.
(2) Move the front lower No. 1 suspension arm sub-assem
REMOVAL
CAUTION / NOTICE / HINT
COMPONENTS (REMOVAL)
Procedure
Part Name Code
1
FRONT AXLE ASSEMBLY
-
INSPECTION
PROCEDURE
1. INSPECT FRONT LOWER BALL JOINT ASSEMBLY
(a) Inspect the turning torque of the ball joint.
(1) Secure the front lower ball joint assembly in a vise using alumin
SEE MORE:
DESCRIPTION The motor generator control ECU (MG ECU) (built into the inverter with converter assembly) compares the engine speed value calculated based on the camshaft position signal input from the ECM versus the engine speed value received from the ECM via CAN communication, and when it has freque
DESCRIPTION
This DTC is output when an open circuit or short occurs in the
communication line between a front center ultrasonic sensor (FLC sensor) and the
front corner ultrasonic sensor (FL sensor), or when a malfunction occurs in a front
center ultrasonic sensor (FLC sensor) on the front.
On-vehicle Inspection
Camshaft Position Sensor "A" Circuit Bank 1 or Single Sensor Algorithm Based Failure (P034006,P034062)
