Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Engine Immobiliser System Incorrect Assembly (B279C95)

Toyota Corolla Cross (2022-2026) Service Manual / Vehicle Interior / Theft Deterrent / Keyless Entry / Smart Key System (for Start Function, Gasoline Model) / Engine Immobiliser System Incorrect Assembly (B279C95)

DESCRIPTION

If a ECM that is incompatible with the immobiliser function is installed, the ECM will store this DTC.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

Note

B279C95

Engine Immobiliser System Incorrect Assembly

A ECM that is incompatible with the immobiliser function is installed. (1-trip detection logic*)

ECM

-
  • *: Only detected while a malfunction is present.
Vehicle Condition and Fail-safe Function when Malfunction Detected

Vehicle Condition when Malfunction Detected

Fail-safe Function when Malfunction Detected

Engine cannot be started

-
Related Data List and Active Test

DTC No.

Data List and Active Test

B279C95

-

CAUTION / NOTICE / HINT

NOTICE:

  • When using the GTS with the ignition switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select the vehicle type under manual mode and enter the following menus: Body Electrical / Smart Key. While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
  • The smart key system (for Start Function) uses the LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the smart key system (for Start Function) after confirming that the communication systems are functioning properly.

    Click here

  • Before replacing the ECM, refer to Registration.

    Click here

  • After performing repairs, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
  • When the ECM is replaced, update the ECU security key.

    Click here

PROCEDURE

1.

REPLACE ECM

(a) Temporarily replace the ECM with a new one.

Click here

NEXT

END (ECM WAS DEFECTIVE)

    READ NEXT:

     Front Floor Electrical Key Oscillator Circuit Open (B27A513)

    DESCRIPTION The certification ECU (smart key ECU assembly) generates a request signal and transmits the signal to the No. 1 indoor electrical key antenna assembly (front floor). For the No. 1 indoor e

     Rear Floor 2 Electrical Key Oscillator Circuit Open (B27A713)

    DESCRIPTION The certification ECU (smart key ECU assembly) generates a request signal and transmits the signal to the No. 3 indoor electrical key antenna assembly (inside luggage compartment). For the

     Crankshaft Position Sensor "A" Signal Compare Failure (P033562)

    DESCRIPTION These DTCs are stored when the engine speed signal sent by the ECM via direct line and the engine speed signal sent via CAN communication do not match. DTC No. Detection Item

    SEE MORE:

     Lost Communication with Stop and Start Control Module Missing Message (U110387)

    DESCRIPTION The ECM and engine stop and start ECU send and receive signals via CAN communication. If a communication error occurs between the ECM and engine stop and start ECU, the ECM stores this DTC. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Note

     Data List / Active Test

    DATA LIST / ACTIVE TEST ACTIVE TEST HINT: Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiri

    © 2020-2026 Copyright www.tcorollacross.com PT NL