Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Customize Parameters

Toyota Corolla Cross (2022-2025) Service Manual / Vehicle Interior / Theft Deterrent / Keyless Entry / Theft Deterrent System / Customize Parameters

CUSTOMIZE PARAMETERS

CUSTOMIZE THEFT DETERRENT SYSTEM

NOTICE:

  • When the customer requests a change in a function, first make sure that the function can be customized.
  • Be sure to make a note of the current settings before customizing.
  • When troubleshooting a function, first make sure that the function is set to the default setting.

HINT:

The following items can be customized.

(a) Customizing with the GTS

(1) Select the setting by referring to the table below.

Wireless Door Lock

Tester Display

Description

Default

Setting

ECU

Panic Function

This function makes it possible to operate the theft deterrent system by continuously pressing the panic switch on the key for 0.8 seconds

ON

0:OFF,1:ON

Main body ECU (Multiplex network body ECU)

    READ NEXT:

     Problem Symptoms Table

    PROBLEM SYMPTOMS TABLE NOTICE: Before replacing the main body ECU (multiplex network body ECU), refer to Registration. for HEV Model: Click here for Gasoline Model: Click here HINT: Trou

     Terminals Of Ecu

    TERMINALS OF ECU CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND POWER DISTRIBUTION BOX ASSEMBLY (a) Remove the main body ECU (multiplex network body ECU) from the power distribution box assem

     Data List / Active Test

    DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a

    SEE MORE:

     O2 Sensor Slow Response - Rich to Lean Bank 1 Sensor 1 (P014C00,P014D00,P015A00,P015B00)

    DESCRIPTION Refer to DTC P003012. Click here HINT: Although the DTC titles say O2 sensor, these DTCs relate to the air fuel ratio sensor (sensor 1). DTC No. Detection Item DTC Detection Condition Trouble Area MIL Note P014C00 O2 Sensor Slow Response - Rich to Lean

     Inspection

    INSPECTION PROCEDURE 1. INSPECT NO. 2 FUEL PRESSURE SENSOR (a) Check the No. 2 fuel pressure sensor output voltage. (1) Apply 5 V between terminals 1 (VC) and 3 (E2). NOTICE: Be careful when connecting the leads, as the No. 2 fuel pressure sensor may be damaged if the leads are conn

    © 2020-2025 Copyright www.tcorollacross.com PT NL