Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Changing the engine switch positions

Driving procedures

  1. OFF ("LOCK" position)

The key can be removed. (The key can be removed only when the shift lever is in P.)

  1. ACC ("ACC" position)

Some electrical components such as the audio system can be used.

  1. ON ( "ON" position)

All electrical components can be used.

  1. START ( "START" position)

For starting the engine.

■Turning the key from ACC to OFF

1. Shift the shift lever to P.

2. Push in the key and turn it to OFF.

Driving procedures

■Key reminder function

A buzzer sounds if the driver's door is opened while the engine switch is in OFF or ACC to remind you to remove the key.

WARNING

■Caution when driving

Do not turn the engine switch to OFF while driving. If, in an emergency, you must turn the engine off while the vehicle is moving, turn the engine switch only to ACC to stop the engine. An accident may result if the engine is stopped while driving.

NOTICE

■To prevent battery discharge

Do not leave the engine switch in ACC or ON for long periods of time without the engine running.

    READ NEXT:

     Engine (ignition) switch (vehicles with a smart key system)

    Performing the following operations when carrying the electronic key on your person starts the engine or changes engine switch modes. Starting the engine 1. Check that the parking brake is set. 2. C

     Stopping the engine

    1. Stop the vehicle completely. 2. Set the parking brake, and shift the shift lever to P. Check the parking brake indicator is illuminated. Do not press the shift lever button after shifting the shi

     Changing engine switch modes

    Modes can be changed by pressing the engine switch with brake pedal released. (The mode changes each time the switch is pressed.) OFF*1 The emergency flashers can be used. ACC*2 Some electrical

    SEE MORE:

     Compressor Solenoid Circuit Short to Ground or Open (P06A014)

    DESCRIPTION In this circuit, the compressor with pulley assembly receives refrigerant compression demand signals from the air conditioning amplifier assembly. Based on this signal, the compressor with pulley assembly changes the amount of compressor output. DTC No. Detection Item DTC

     Headlight Dimmer Switch Circuit

    DESCRIPTION The steering sensor receives the following switch information: Light control switch in DRL OFF*1, TAIL, HEAD, AUTO position Dimmer switch in high, low or high flash (pass) position Fog light switch in front*2 or off position *1: w/ DRL OFF Switch *2: w/ Fog Light WIRING

    © 2020-2025 Copyright www.tcorollacross.com