Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Air outlet layout and operations

Toyota Corolla Cross (2022-2025) Owner's Manual / Interior features / Using the air conditioning system and defogger / Air outlet layout and operations

■ Location of air outlets

The air outlets and air volume changes according to the selected air flow mode.

Using the air conditioning system and defogger

■ Adjusting the position of and opening and closing the air outlets

Front center

Using the air conditioning system and defogger

Direct air flow to the left or right, up or down

Front right-hand side

Using the air conditioning system and defogger

  1. Direct air flow to the left or right, up or down
  2. Close the vent
  3. Open the vent

Front left-hand side

Using the air conditioning system and defogger

  1. Direct air flow to the left or right, up or down
  2. Close the vent
  3. Open the vent

Rear

Using the air conditioning system and defogger

  1. Direct air flow to the left or right, up or down
  2. Turn the knob to open or close the vents

WARNING

■To prevent the windshield defogger from operating improperly

Do not place anything on the instrument panel which may cover the air outlets. Otherwise, air flow may be obstructed, preventing the windshield defoggers from defogging.

Using the air conditioning system and defogger

    READ NEXT:

     Heated steering wheel/seat heaters

    Heated steering wheel Warms up the grip of the steering wheel Seat heaters Warm up the seat upholstery WARNING ■To prevent minor burn injuries Care should be taken if anyone in the following c

     Using the interior lights

    Interior lights list Location of the interior lights Rear interior light Door trim lights (if equipped) Front interior/personal lights Center tray light (if equipped) Front cup holder light (

     Using the storage features

    SEE MORE:

     Adjustment

    ADJUSTMENT PROCEDURE 1. REMOVE WASHER NOZZLE SUB-ASSEMBLY Click here 2. ADJUST WASHER NOZZLE SUB-ASSEMBLY (a) Select a washer nozzle sub-assembly so that the position the washer fluid hits the windshield will be within the standard area. Replace the washer nozzle sub-assembly with the selected o

     Yaw Rate Sensor Circuit Voltage Out of Range (C00631C)

    DESCRIPTION The airbag ECU assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition. The skid control ECU (brake actuator assembly) calibrates the sensitivity of the yaw rate sensor (airbag ECU assembly) based on signals from the steering sensor and speed se

    © 2020-2025 Copyright www.tcorollacross.com PT NL