Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Utility

Toyota Corolla Cross (2022-2026) Service Manual / Vehicle Interior / Supplemental Restraint Systems / Airbag System / Utility

UTILITY

WRITE VIN/VEHICLE IDENTIFICATION NUMBER

NOTICE:

  • When the airbag sensor assembly is replaced, it is necessary to write the VIN/Vehicle Identification Number.
  • Since the VIN information of the airbag sensor assembly is acquired via ECM, it is necessary to first write the VIN of ECM.

    After writing ECM VIN information, first turn the ignition switch from off to ON and then write VIN information to the airbag sensor assembly.

    • for M20A-FXS:

      Click here

    • for M20A-FKS:

      Click here

(a) Using the GTS, write the VIN/Vehicle Identification Number.

Body Electrical > SRS Airbag > Utility

Tester Display

VIN Memory

SWITCHING SPECIFICATION INFORMATION

NOTICE:

  • When the airbag sensor assembly is replaced, it is necessary to switch the specification information.
  • The airbag sensor assembly specification information is acquired from the forward recognition camera.

(a) Using the GTS, switch the specification information.

Body Electrical > SRS Airbag > Utility

Tester Display

Load Specification Information

    READ NEXT:

     Problem Symptoms Table

    PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of pr

     Terminals Of Ecu

    TERMINALS OF ECU AIRBAG ECU ASSEMBLY Terminal No. Terminal Symbol Destination O1-3 PLR- Rear pretensioner squib LH (Rear seat outer belt assembly LH) O1-4 PLR+

     Freeze Frame Data

    FREEZE FRAME DATA DESCRIPTION (a) When an airbag system DTC is stored, the airbag ECU assembly stores the current vehicle (ECU or sensor) state as Freeze Frame Data. CHECK FREEZE FRAME DATA CAUTION:

    SEE MORE:

     Diagnostic Trouble Code Chart

    DIAGNOSTIC TROUBLE CODE CHART Smart Key System (for Start Function) DTC No. Detection Item Link B227111 IG Circuit Short to Ground B227411 ACC Circuit Short to Ground B227511 Starter Circuit Short to Ground B227512 Start

     Transmission Control Switch Circuit

    DESCRIPTION After moving the shift lever to M, it is possible to change the shift range between M1 and M10 using the shift lever. Moving the shift lever to "+" once raises the shift range by one, and moving the shift lever to "-" lowers the shift range by one. WIRING DIAG

    © 2020-2026 Copyright www.tcorollacross.com PT NL