Toyota Corolla Cross: Stop & Start system
The Stop & Start system stops and starts the engine according to brake pedal or shift lever operation when the vehicle is stopped, such as at a stoplight, intersection, etc., in order to improve fuel economy and reduce noise pollution caused by the engine idling.
Stop & Start system operation
■ Stopping the engine
While driving with the D shift position selected, depress the brake pedal and stop the vehicle.
The engine will stop automatically.
When the engine stops, the Stop & Start indicator will illuminate.
.png)
■ Restarting the engine
Release the brake pedal. The engine will start automatically.
When the engine starts, the Stop & Start indicator will turn off.
■ When the brake hold system is operating
- When the engine is stopped by the Stop & Start system, if the brake pedal is released the engine will remain stopped.
- If the accelerator pedal is depressed while the engine is stopped by the Stop & Start system, the engine will restart.
- While the engine is stopped by the Stop & Start system, if the engine is restarted, the brake hold system will continue to apply the brakes, unless the operation conditions of the brake hold system are no longer met.
■ When the dynamic radar cruise control with
full-speed range is operating
- When the vehicle is stopped by the dynamic radar cruise control with full-speed range, the engine will stop automatically even though the brake pedal is not depressed.
- When the preceding vehicle starts off, the engine will restart automatically.
- If the engine is restarted by the Stop & Start system while the vehicle is stopped by the dynamic radar cruise control with full-speed range, the vehicle will remain stopped.
Disabling the Stop & Start system
Press the Stop & Start cancel switch to disable the Stop & Start system.
The Stop & Start cancel indicator will illuminate.
Pressing the switch again will enable the Stop & Start system and the Stop & Start cancel indicator will turn off.
.png)
■Automatic enabling of the Stop & Start system
If the Stop & Start system is disabled using the Stop & Start cancel switch, it will be automatically re-enabled once the engine switch is turned off and then the engine is started.
READ NEXT:
Hill-start assist control
When the engine is stopped by
the Stop & Start system when
the vehicle is on an incline,
when the brake pedal is
released, brake force is temporarily
maintained to prevent the
vehicle from rolling
BSM (Blind Spot Monitor)
The Blind Spot Monitor is a
system that uses rear side
radar sensors installed on
the inner side of the rear
bumper on the left and right
side to assist the driver in
confirming safety when
changing l
Blind Spot Monitor operation
■ Objects that can be detected while driving
The Blind Spot Monitor uses rear side radar sensors to detect the following
vehicles traveling in adjacent lanes and advises the driver of
the presence o
SEE MORE:
Torque Converter Clutch Pressure Control Solenoid Control Circuit Short to Battery
(P275612)
DESCRIPTION
Using the current from the TCM, the shift solenoid valve SLU controls the lock-up
clutch pressure, and performs lock-up and flex lock-up control.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
MIL
Memory
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT DRIVE SHAFT ASSEMBLY
(a) Check that there is no excessive play in the radial direction of
the outboard joint.
(b) Check that the inboard joint slides smoothly in the thrust direction.
(c) Check that t
