Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Rear windshield wiper and washer

NOTICE

■When the rear window is dry

Do not use the wiper, as it may damage the rear window.

Operating the wiper lever

Operating the switch operates the rear wiper as follows.

Operating the lights and wipers

  1. (U.S.A.) or (Canada)
    Off
  2. (U.S.A.) or (Canada)
    Intermittent window wiper operation
  3. (U.S.A.) or (Canada)
    Normal window wiper operation

Operating the lights and wipers

  1. Washer/wiper dual operation

Pushing the lever operates the wiper and washer.

The wiper will automatically operate a couple of times after the washer squirts.

■The rear window wiper and washer can be operated when

The engine switch is in ON.

■If no washer fluid sprays

Check that the washer nozzle is not blocked if there is washer fluid in the washer fluid tank.

■Back door opening linked rear window wiper stop function

When the rear window wiper is operating, if a back door is opened while the vehicle is stopped, operation of the rear window wiper will be stopped to prevent anyone near the vehicle from being sprayed by water from the wiper. When the back door is closed, wiper operation will resume.

NOTICE

■When there is no washer fluid spray from the nozzle

Damage to the washer fluid pump may be caused if the lever is pulled toward you and held continually.

■When a nozzle becomes blocked

In this case, contact your Toyota dealer. Do not try to clear it with a pin or other object. The nozzle will be damaged.

    READ NEXT:

     Refueling

    Opening the fuel tank cap Perform the following steps to open the fuel tank cap: Perform the following steps to open the fuel tank cap: Turn the engine switch off and ensure that all the doors and

     Using the driving support systems

     Toyota Safety Sense 3 software update

    It is necessary to enter a connected services contract, provided by Toyota, to use these functions. For details, contact your Toyota dealer. WARNING ■For safe use When the Toyota Safety Sense 3 soft

    SEE MORE:

     Power Back Door does not Operate Using Outside Switch

    DESCRIPTION The No. 1 power back door control switch signal is sent to the multiplex network door ECU. If the power back door does not operate using the No. 1 power back door control switch, a No. 1 power back door control switch circuit malfunction is a possible cause. WIRING DIAGRAM CAUTION / N

     Barometric Pressure Sensor "A" Circuit Short to Ground (P222611)

    DESCRIPTION The atmospheric pressure sensor is built into the ECM. The ECM provides optimal control in response to atmospheric pressure fluctuations. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Note P222611 Barometric Pressure Sensor "A" Circuit Sh

    © 2020-2026 Copyright www.tcorollacross.com PT NL