Toyota Corolla Cross: Rear Door Lock
READ NEXT:
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 PRECAUTION
-
- -
2 DISCONNECT CABLE FROM NEGATIV
INSPECTION PROCEDURE 1. INSPECT REAR DOOR LOCK WITH MOTOR ASSEMBLY LH
(a) Check the door lock motor operation. (1) Apply auxiliary battery voltage to the motor connector and check the operation
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 REAR DOOR LOCK AND UNLOCK KNOB INSIDE LOCKING CABLE
69780E -
SEE MORE:
CAUTION / NOTICE / HINT
HINT:
Use the following procedure to troubleshoot the tire pressure warning system.
Make sure that the wireless door lock control system has exited diagnostic
mode before performing the following procedure.
*: Use the GTS.
PROCEDURE
1.
TERMINALS OF ECU CHECK MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
(a) Disconnect the L7 multiplex network master switch assembly connector.
(b) Measure the voltage and resistance according to the value(s) in the table below.
HINT: Measure the values on the wire harness side with the connector disc
Removal
How To Proceed With Troubleshooting
