Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Problem Symptoms Table

Toyota Corolla Cross (2022-2026) Service Manual / Vehicle Interior / Seat Belt / Seat Belt Warning System / Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

NOTICE:

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

HINT:

  • Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  • Inspect the fuses and relays related to this system before inspecting the suspected areas below.
Seat Belt Warning System

Symptom

Suspected Area

Link

Driver side seat belt warning light does not operate

Refer to the "Driver side seat belt warning light does not operate''

Front passenger side seat belt warning light does not operate

Refer to the "Front passenger side seat belt warning light malfunction''

Rear seat belt warning light malfunction

Refer to the "Rear Seat Belt Warning Light Malfunction"

Seat belt warning light does not operate for all seats

Combination meter assembly

Seat belt warning buzzer does not operate

Check customized settings using the GTS

Combination meter assembly

    READ NEXT:

     Terminals Of Ecu

    TERMINALS OF ECU CHECK POWER DISTRIBUTION BOX ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (a) Remove the main body ECU (multiplex network body ECU). Click here *1 Power

     Data List / Active Test

    DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whethe

     On-vehicle Inspection

    ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT DRIVER SEAT BELT WARNING LIGHT HINT: The seat belt warning light on the combination meter assembly is used for both the driver seat and front passenger sea

    SEE MORE:

     Diagnosis System

    DIAGNOSIS SYSTEM OBD II (except Mexico Models) When troubleshooting OBD II (On-Board Diagnostics) vehicles, the GTS (complying with SAE J1978) must be connected to the DLC3 (Data Link Connector 3) of the vehicle. Various data in the vehicle's ECM (Engine Control Module) can be then read. OBD II

     Precaution

    PRECAUTION PRECAUTION FOR REPLACING PART (a) After replacing the radio and display receiver assembly or DCM (telematics transceiver), some functions and services may not be available after the ignition switch to ACC for first time or second time. Make sure to perform the following operations

    © 2020-2026 Copyright www.tcorollacross.com PT NL