Toyota Corolla Cross: Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY
(a) for LH Belt:
| (1) Measure the resistance according to the value(s) in the table below.
Standard Resistance: |
Tester Connection | Condition |
Specified Condition | |
O85-5(LBR+) - O85-4(LBR-) |
Rear LH seat belt unfastened |
Below 1 Ω | |
Rear LH seat belt fastened |
10 kΩ or higher | If the result is not as specified, replace the rear seat inner with center belt assembly. |
 |
|
*a | Component without harness connected
(Rear Seat Inner with Center Belt Assembly) | | |
(b) for Center Belt:
| (1) Measure the resistance according to the value(s) in the table below.
Standard Resistance: |
Tester Connection | Condition |
Specified Condition | |
O86-1(CBR+) - O86-2(CBR-) |
Rear center seat belt unfastened |
Below 1 Ω | |
Rear center seat belt fastened |
10 kΩ or higher | If the result is not as specified, replace the rear seat inner with center belt assembly. |
 |
|
*a | Component without harness connected
(Rear Seat Inner with Center Belt Assembly) | | |
READ NEXT:
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 REAR SEAT INNER WITH CENTER BELT ASSEMBLY
73480
-
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 REAR CENTER SEAT OUTER BELT ASSEMBLY
73350C -
- -
2 BEN
SEE MORE:
The brake hold system
keeps the brake applied
when the shift lever is in D,
M or N with the system on
and the brake pedal has
been depressed to stop the
vehicle. The system
releases the brake when the
accelerator pedal is
depressed with the shift
lever in D or M to allow
smooth start off.
Enabling t
DIAGNOSTIC TROUBLE CODE CHART
Blind Spot Monitor System
DTC No.
Detection Item
Link
C1AB411
Outer Mirror Indicator (Module "B" Side) Circuit Short
to Ground
C1AB412
Outer Mirror Indi
