Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Inspection

INSPECTION

PROCEDURE

1. INSPECT FRONT SEAT OUTER BELT ASSEMBLY

(a) Before installing the front seat outer belt assembly, check the ELR function.

NOTICE:

Do not disassemble the retractor.

(1) When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.

If the result is not as specified, replace the front seat outer belt assembly.

*a

Unlock

*b

Lock

*c

45°

    READ NEXT:

     Installation

    INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION) Procedure Part Name Code 1 FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY 73200A - -

     Disposal

    DISPOSAL CAUTION / NOTICE / HINT CAUTION: Before performing pre-disposal deployment of any SRS part, review and closely follow all applicable environmental and hazardous material regulations. Pre-di

     Rear Center Seat Outer Belt Assembly

    SEE MORE:

     Generator Position Sensor Circuit Voltage Below Threshold (P0A4B16,P0A4B1F)

    DTC SUMMARY MALFUNCTION DESCRIPTION These DTCs indicate that the resolver output signal is abnormal. The cause of this malfunction may be one of the following: Area Main Malfunction Description Inverter low-voltage circuit The connectors are not connected properly H

     Cylinder 1 Injector "A" Circuit Open (P020113-P020413,P062D13)

    DESCRIPTION The D-4S system has two fuel injection systems. One is an in-cylinder direct injection system that directly injects pressurized fuel into the combustion chamber. The other is an intake port injection system. The ECM determines which fuel injection system to use in accordance with the eng

    © 2020-2025 Copyright www.tcorollacross.com PT NL