Toyota Corolla Cross: Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR SHOCK ABSORBER ASSEMBLY
(a) Compress and extend the rear shock absorber assembly rod 4 or more times.
Standard:
When compressed and extended at a constant speed, the stroke of the shock absorber
rod is smooth with no abnormal resistance or sounds. When extended, the shock absorber
rod returns to its original position at a constant speed with no abnormal sounds.
HINT:
If there are any abnormalities, replace the rear shock absorber assembly with
a new one.
READ NEXT:
INSTALLATION
CAUTION / NOTICE / HINT
COMPONENTS (INSTALLATION)
Procedure
Part Name Code
1
REAR SUSPENSION SUPPORT ASSEM
DISPOSAL
PROCEDURE
1. DISPOSE OF REAR SHOCK ABSORBER ASSEMBLY
(a) Extend the piston rod and secure the rear shock absorber assembly
at an angle in a vise.
SEE MORE:
1. Remove any dirt or foreign
matter from the wheel contact
surface.
If foreign matter is on the wheel
contact surface, the wheel nuts
may loosen while the vehicle is in motion, causing the tire to come off.
2. Install the tire and loosely
tighten each wheel nut by
hand by approximately the
same a
DESCRIPTION
Detection Item
Symptom
Trouble Area
Certification ECU Communication Stop Mode
Communication stop for "Certification (Smart)" and/or "Power Management"
is indicated on the "Communication Bus Check&q
