Toyota Corolla Cross: Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR SHOCK ABSORBER ASSEMBLY
(a) Compress and extend the rear shock absorber rod 4 or more times.
Standard:
When compressed and extended at a constant speed, the stroke of the shock absorber
rod is smooth with no abnormal resistance or sounds. When extended, the shock absorber
rod returns to its original position at a constant speed with no abnormal sounds.
(b) If there are any abnormalities, replace the rear shock absorber assembly
with a new one.
READ NEXT:
INSTALLATION
CAUTION / NOTICE / HINT
COMPONENTS (INSTALLATION)
Procedure
Part Name Code
1
REAR NO. 1 SPRING BUMPER
DISPOSAL
PROCEDURE
1. DISPOSE OF REAR SHOCK ABSORBER ASSEMBLY
(a) Extend the piston rod and secure the rear shock absorber assembly
at an angle in a vise.
SEE MORE:
INSPECTION PROCEDURE 1. INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY LH
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Condition
Specified Condition
O30-1 - Switch body
DESCRIPTION Refer to DTC P222611. Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Note
P222615 Barometric Pressure Sensor "A" Circuit Short to Battery or Open
Diagnosis condition:
Ignition switch ON
Abnormal conditio
