Toyota Corolla Cross: How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
- Use these procedures to troubleshoot the power integration system.
- *: Use the GTS.
PROCEDURE
|
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
.gif)
|
2. |
INSPECT AUXILIARY BATTERY VOLTAGE |
(a) Measure the auxiliary battery voltage with the ignition switch off.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding.
|
|
3. |
CHECK COMMUNICATION FUNCTION OF CXPI COMMUNICATION SYSTEM* |
(a) Using the GTS, check the CXPI communication function to ensure that there are no malfunctions in the communication system.
| DTCs output | .gif) |
GO TO CXPI COMMUNICATION SYSTEM |
|
|
4. |
CHECK VEHICLE CONTROL HISTORY* |
(a) Using the GTS, check for Vehicle Control History (RoB).
Body Electrical > Power Distribution Box > Utility|
Tester Display |
|---|
|
Vehicle Control History (RoB) |
(b) If the vehicle control history is output, record it.
|
Result |
Proceed to |
|---|---|
|
Vehicle Control History (RoB) is not output |
A |
|
Vehicle Control History (RoB) is output |
B |
| B | |
GO TO VEHICLE CONTROL HISTORY |
|
|
5. |
CHECK FOR DTC* |
(a) Check for DTCs and make a note of any codes that are output.
(b) Clear the DTCs.
Body Electrical > Power Distribution Box > Clear DTCs(c) Recheck for DTCs.
Body Electrical > Power Distribution Box > Trouble Codes| DTCs output | |
GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
|
6. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to the Problem Symptoms Table.
Click here .gif)
| Fault is listed in problem symptoms table | |
ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE |
|
|
7. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Data List / Active Test
Click here
(b) Terminals of ECU
Click here
(c) Problem Symptoms Table
Click here
|
|
8. |
ADJUST, REPAIR OR REPLACE |
| NEXT | |
END |
